Show pageDiscussionOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. <button collapse="docol-commands" block="true" >**Errors and error handlers** <badge>17</badge> <badge>7 NEW</badge></button> <collapse id="docol-commands" collapsed="true"> ^ Command ^ Short Description ^ ^ | **[[manual:chapter6:docol:cmd_exitrpl|EXITRPL]]** | Panic exit - abort the RPL engine. | <badge>NEW</badge> | | **[[manual:chapter6:docol:cmd_eval1next|EVAL1NEXT]]** | Perform EVAL1 on the next object in a secondary and skips it | <badge>NEW</badge> | | **[[manual:chapter6:docol:cmd_resume|RESUME]]** | End error handler and resume execution of main program | <badge>NEW</badge> | | **[[manual:chapter6:docol:cmd_doerr|DOERR]]** | Issue an error condition | <badge>CHANGED</badge> | | **[[manual:chapter6:docol:cmd_errn|ERRN]]** | Recall the previous error code | <badge>CHANGED</badge> | | **[[manual:chapter6:docol:cmd_errm|ERRM]]** | Recall the previous error message | <badge>CHANGED</badge> | | **[[manual:chapter6:docol:cmd_err0|ERR0]]** | Clear previous error code | | | **[[manual:chapter6:docol:cmd_halt|HALT]]** | Halt the execution of RPL code | | | **[[manual:chapter6:docol:cmd_cont|CONT]]** | Continue execution of a halted program | | | **[[manual:chapter6:docol:cmd_sst|SST]]** | Single-step through a halted program, skip over subroutines | | | **[[manual:chapter6:docol:cmd_sstin|SST↓]]** | Single-step through a halted program, goes into subroutines | | | **[[manual:chapter6:docol:cmd_kill|KILL]]** | Terminate a halted program | | | **[[manual:chapter6:docol:cmd_setbkpoint|SETBKPOINT]]** | Set a breakpoint on a halted program | <badge>NEW</badge> | | **[[manual:chapter6:docol:cmd_clrbkpoint|CLRBKPOINT]]** | Remove a breakpoint | <badge>NEW</badge> | | **[[manual:chapter6:docol:cmd_dbug|DBUG]]** | Halt the given program at the first instruction for debugging | | | **[[manual:chapter6:docol:cmd_blameerr|BLAMEERR]]** | Issue an error condition, blame other program for it | <badge>NEW</badge> | | **[[manual:chapter6:docol:cmd_exit|EXIT]]** | Early exit from the current program or loop | <badge>NEW</badge> | </collapse> manual/chapter6/docol.txt Last modified: 2021/08/13 13:12(external edit)