manual:chapter6:angles:cmd_tagdms

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
manual:chapter6:angles:cmd_tagdms [2019/10/22 13:27]
jojo1973 Fixed internal link
manual:chapter6:angles:cmd_tagdms [2019/10/22 13:48]
jojo1973
Line 28: Line 28:
   * **MM** expresses the number of minutes of arc and ranges from ''00'' to ''59'';   * **MM** expresses the number of minutes of arc and ranges from ''00'' to ''59'';
   * **SS** expresses the number of seconds of arc and ranges from ''00'' to ''59'';   * **SS** expresses the number of seconds of arc and ranges from ''00'' to ''59'';
-  * **xxx...** expresses the fraction of seconds of arc.+  * **xxx...** expresses the remaining fraction of seconds of arc.
      
 When a scalar is converted to an angle in degrees / minutes / seconds no check is performed to ensure that the digits at **MM** and **SS** positions range from ''00'' to ''59''. However addition of ''0'' (or multiplication by ''1'') will return a properly //normalized// angle. When a scalar is converted to an angle in degrees / minutes / seconds no check is performed to ensure that the digits at **MM** and **SS** positions range from ''00'' to ''59''. However addition of ''0'' (or multiplication by ''1'') will return a properly //normalized// angle.
  • manual/chapter6/angles/cmd_tagdms.txt
  • Last modified: 2021/09/16 15:40
  • by jojo1973