Differences

This shows you the differences between two versions of the page.

--- manual:chapter4:usb [2019/11/02 10:58]
jojo1973 Added USBAUTORCV
+++ manual:chapter4:usb [2021/07/28 08:44]
claudio [Backup and Restore]
@@ Line 13: / Line 13: @@
 In case of disconnection the status bar will show **[ Click to reconnect ]** allowing a quick reconnection of the calculator.
+On the models that support USB power, the battery indicator will turn gray when the USB cable is plugged, to indicate it's drawing power from the USB port.
 ==== Data Transfer ====
@@ Line 63: / Line 64: @@
 **newRPL** allows archiving and restoring of memory across the USB wire. Simply:
-  - run ''[[manual:chapter6:usb:cmd_usbrestore|USBRESTORE]]'' command on the receiving calculator: the command needs a time-out in seconds, so <code>30 USBRESTORE</code> will usually suffice;
+  - run ''[[manual:chapter6:usb:cmd_usbrestore|USBRESTORE]]'' on the receiving calculator: the command needs a time-out in seconds, so <code>30 USBRESTORE</code> will usually suffice;
   - run ''[[manual:chapter6:usb:cmd_usbarchive|USBARCHIVE]]'' on the source machine.
@@ Line 72: / Line 73: @@
 | HP40GS  | 256 KiB  |
 | HP50g  | 512 KiB  |
-| newRPL Desktop  | 1 MiB  |
+| Prime G1  | 32 MiB  |
+| newRPL Desktop  | 10 MiB  |
-----
+The above procedure will send the backup file to the other end of the wire. **newRPL Desktop** has also options to directly execute USBARCHIVE on the remote calculator and save the file to disk, without affecting the simulated calculator.
 ==== USB Operations ====
@@ Line 80: / Line 82: @@
 | ''[[manual:chapter6:usb:cmd_usbsend|USBSEND]]''  | Send an object across USB wire  | '' « "CONNECTED!" » [[manual:chapter6:usb:cmd_usbsend|USBSEND]]''  |
 | ''[[manual:chapter6:usb:cmd_usbrecv|USBRECV]]''  | Manually receive an object across USB wire  | ''5 [[manual:chapter6:usb:cmd_usbrecv|USBRECV]]''  |
-| ''[[manual:chapter6:usb:cmd_usbautorcv|USBAUTORCV]]''  | Manually receive an object across USB wire and ''[[manual:chapter6:operators:cmd_ovr_xeq|XEQ]]''%%'%%te it  | ''[[manual:chapter6:usb:cmd_usbrecv|USBAUTORCV]]''  |
+| ''[[manual:chapter6:usb:cmd_usbautorcv|USBAUTORCV]]''  | Manually receive an object across USB wire and ''[[manual:chapter6:operators:cmd_ovr_xeq|XEQ]]''%%'%%te it  | ''[[manual:chapter6:usb:cmd_usbautorcv|USBAUTORCV]]''  |
 | ''[[manual:chapter6:usb:cmd_usbarchive|USBARCHIVE]]''  | Send a complete backup across USB wire  | ''[[manual:chapter6:usb:cmd_usbarchive|USBARCHIVE]]''  |
 | ''[[manual:chapter6:usb:cmd_usbrestore|USBRESTORE]]''  | Receive a backup across USB wire and restore it  | ''30 [[manual:chapter6:usb:cmd_usbrestore|USBRESTORE]]'' |