manual:chapter1:installation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
manual:chapter1:installation [2021/07/28 08:36]
claudio [newRPL ROM installation Instructions (for Prime G1 model only)]
manual:chapter1:installation [2021/07/28 08:37] (current)
claudio [newRPL ROM installation Instructions (for Prime G1 model only)]
Line 37: Line 37:
   - Start the Connectivity Kit again, this time update the calculator firmware as usual.   - Start the Connectivity Kit again, this time update the calculator firmware as usual.
   - After it's complete, the calculator will start normally. To switch to newRPL, press **On+Symb** to reset the calculator, then quickly **Esc<sup>hold</sup>**. Don't release Esc until you see a message from newRPL saying that "Install will wipe out RAM"   - After it's complete, the calculator will start normally. To switch to newRPL, press **On+Symb** to reset the calculator, then quickly **Esc<sup>hold</sup>**. Don't release Esc until you see a message from newRPL saying that "Install will wipe out RAM"
-  - Once **newRPL** is installed for the first time, all future updates can also be made using **newRPL Desktop**.+  - Once **newRPL** is installed for the first time, all future updates can be made using **newRPL Desktop**. Doing it this way will update **newRPL** without affecting the Prime firmware at all.
   - **Important**: If you wish to update the Prime firmware to a newer version, don't forget to run the **Prime Firmware Bundler** after the Connectivity Kit downloads and extracts the file, and before you flash it to the calculator. Flashing a stock firmware without **newRPL** bundled in will completely remove **newRPL** from the calculator.   - **Important**: If you wish to update the Prime firmware to a newer version, don't forget to run the **Prime Firmware Bundler** after the Connectivity Kit downloads and extracts the file, and before you flash it to the calculator. Flashing a stock firmware without **newRPL** bundled in will completely remove **newRPL** from the calculator.
  
  • manual/chapter1/installation.1627486573.txt.gz
  • Last modified: 2021/07/28 08:36
  • by claudio