Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
manual:chapter1:installation [2021/07/28 08:31] claudio [How to revert to the stock ROM] |
manual:chapter1:installation [2021/07/28 08:37] (current) claudio [newRPL ROM installation Instructions (for Prime G1 model only)] |
||
---|---|---|---|
Line 37: | Line 37: | ||
- Start the Connectivity Kit again, this time update the calculator firmware as usual. | - Start the Connectivity Kit again, this time update the calculator firmware as usual. | ||
- After it's complete, the calculator will start normally. To switch to newRPL, press **On+Symb** to reset the calculator, then quickly **Esc< | - After it's complete, the calculator will start normally. To switch to newRPL, press **On+Symb** to reset the calculator, then quickly **Esc< | ||
- | - Once **newRPL** is installed for the first time, all future updates can also be made using **newRPL Desktop**. | + | - Once **newRPL** is installed for the first time, all future updates can be made using **newRPL Desktop**. Doing it this way will update **newRPL** without affecting the Prime firmware at all. |
+ | - **Important**: | ||
====How to revert to the stock ROM==== | ====How to revert to the stock ROM==== |