Differences

This shows you the differences between two versions of the page.

--- manual:chapter1:installation [2021/07/28 08:35]
claudio [newRPL ROM installation Instructions (for Prime G1 model only)]
+++ manual:chapter1:installation [2021/07/28 08:36]
claudio [newRPL ROM installation Instructions (for Prime G1 model only)]
@@ Line 38: / Line 38: @@
   - After it's complete, the calculator will start normally. To switch to newRPL, press **On+Symb** to reset the calculator, then quickly **Esc<sup>hold</sup>**. Don't release Esc until you see a message from newRPL saying that "Install will wipe out RAM"
   - Once **newRPL** is installed for the first time, all future updates can also be made using **newRPL Desktop**.
-  - **Important**: If you wish to update the Prime firmware to a newer version, don't forget to run the **Prime Firmware Bundler** after the Connectivity Kit downloads and extracts the file, and before you flash it to the calculator. Flashing a stock firmware without *newRPL** bundled in will completely remove **newRPL** from the calculator.
+  - **Important**: If you wish to update the Prime firmware to a newer version, don't forget to run the **Prime Firmware Bundler** after the Connectivity Kit downloads and extracts the file, and before you flash it to the calculator. Flashing a stock firmware without **newRPL** bundled in will completely remove **newRPL** from the calculator.
 ====How to revert to the stock ROM====